PR 4 Accessories

Air filter oil
Easy to use aerosol spray.
FILTER – $10

Air filter cleaner

Get your Twin Air AJP filter CLEAN!! 12oz
FFC – $10

Foam filter fluid

Super Tacky! 1 liter

Spray & polish
Get that new bike shine! 12oz
SP – $10

chain wax
for standard, X-Ring, and O-Ring chains. 10oz
CW – $10

Premium motorcycle wash
Get your AJP looking new again! 1 quart
MWIL – $10

Golden4 Semi-Synthetic 20W-50 Oil
Perfect for all PR3 & PR4 models. 1 liter
GS42050 – $10

Shorai lightweight lithium battery.
Saves almost 4lbs as compared to a lead acid battery and has more power too!
MC1020 – $115

Rear Fender Rack – fits all PR3 and PR4 models.
Hi-quality brushed stainless steel rack, custom made for AJP. Includes all mounting hardware needed as shown. Some drilling of the fender is required.
MC1019 – $99

Race CDI – fits all PR3 and PR4 models.
Direct replacement for stock CDI. Improves throttle response and raises rev limit.
MC1018 – $30

Factory Power-Up Kit – Fits all 240cc PR3 & PR4 models.
Includes camshaft, bearing, o-ring, plus carb jets. Provides a noticeable increase in power. We recommend combining this kit with either our FMF or Belparts exhaust system in order to maximize the power benefits.
00MTS01A0172 – $298

AJP BannerShow your colors! AJP Factory Banner. Measures 8 feet long x 1 foot high.
Made of heavy duty material with grommets on 4 corners as well as along length bottom and top.
MC1017 – $45

Spark Arrestor insert – fits PR3 & PR4
Fits Belparts muffler only, NOT stock PR3/4 Enduro muffler
MC1016 – $30

MX Race Kit to fit the PR3 & PR4.
Includes racing wire harness, on/off kill switch, front number plate, and number plate bracket. Eliminates all lighting, meter, and switchgear – which results in a weight savings of over 4 pounds! Combine this kit with a lithium battery and our billet footpegs to save a total of 9lbs!
MC1015 – $189

38 tooth Aluminum rear sprocket to fit the PR3 models only.
This sprocket is 1.5lbs lighter than the stock rear sprocket offering a noticeable reduction in un-sprung and rotational mass! Also lengthens the gearing slightly by 1 tooth less than stock – offering a slightly higher top speed in each gear.
MC1014 – $79.99


AJP Factory pit/garage mat
measures 75″ x 45″.
00MES01A0082 – $159

FMF PowerCore 4 Spark Arrestor Muffler built to fit our PR3 & PR4.
Includes all mounting hardware – slips right on to stock attachment points. USFS approved screen type removable spark arrestor included. This muffler flows better than our stock muffler – resulting in an improvement in power and throttle response.
MC1011 – $395

Magura Hydraulic Clutch Kit – Fits PR3 & PR4.
Provides a very consistent clutch feel and engagement point at all times. Comes completely assembled and pre-bled, ready for E-Z install. Also features the backwards bending clutch lever feature from Magura – no more broken clutch levers!
MC1003 – $335

High Performance complete exhaust system with resonator style header to fit the PR3 & PR4
Boosts Torque & Improves Throttle Response
00MTS04A0053 – $499

Full Coverage Aluminum Skid Plate to fit PR3 & PR4
00MTS01A0124 – $129

AJP Factory Foot Pegs. Red Anodized Billet Aluminum with Stainless Steel grip inserts.
Weighs .6lbs less than the stock pegs! Uses stock mounting hardware, fits all AJP models – PR3 thru PR5R.
00QUS03A0037 – $99 pair

Factory rear suspension link – lower the seat height of your stock PR3 or PR4 by 1 full inch!
Results in a new seat height of 33.5 inches on a PR3 and 35.5 inches on a PR4. Shorter side stand (00QUS04A0044) is recommended for the PR4 application. Some PR3’s will need the stock side-stand bracket lightly modified to allow the bike to lean correctly with this link installed.
00STC07C0004 – $99.

Factory High Flow Intake Kit.

Same kit as used by the Factory AJP Team in the World Extreme Enduro events!
Kit includes air box base plate insert, intake boot and clamp, pre-jetted Keihin 30mm flat slide carburetor, matched intake manifold, fuel hose, and throttle cable. Installing this kit will lower the weight of your bike by 1 lb, provide a much lighter throttle-pull effort than stock, and add 3+ HP across the entire rev range!
MC1022 – $495
Note: This kit works best in combination with a free flowing muffler such as the Belparts or FMF muffler we offer.





AJP Team hat – just like the Factory guys wear!
One size fits most with adjustable Velcro strap in rear.
MC1007 – $19.95

AJP Team t-shirt.
MC1008 – Large, $19.95 each

AJP Team t-shirt.
MC1009 – XL. $19.95 each

Comments are closed.